Advertisement
TOUCH 2 WITH GO – Volume related issues
1-
Bluetooth and Navigation volume changes after Ignition off
2-
Impossible to change volume level in HandsFree mode
1- Bluetooth and Navigation volume changes after Ignition off
Phenomenon description:
-
Bluetooth call volume and ringtone volume resets to 0 on the display with every ACC
cycle
-
Volume can also suddenly increase to a too high level by itself
-
On Land Cruiser and Rav4, an audible reset to a lower volume is also observed
Supplier: Harman / Fujitsu Ten – Denso ten
This phenomenon can occur on Extension Box and DA software lower than mentioned in
below table.
The problem has been resolved as from the softwares versions shown below table or higher.
Minimum Extension Box Required Software Version: 6.9.0
Minimum Display Audio Required Software Version:
Camry, depends which DA-unit type fitted
Top page
How to access the Service Menu
How to check DTC codes
Vehicle Model
Hilux
Verso S
Yaris
Alphard
Hilux MY2015
How to Identify T2wG and Device
How to access the Repair Manual
How to install latest softwares
Minimum Required Software Version
FE3063
FE3063
XE3934
XE3934
XE3934
GE3934 / VE3934
ID
NG Techdoc
Unknown issue
DA
DA & Ext. Box
Advertisement
