Advertisement
Software Recovery
Following the previous recommendations for sw update:
-
Engine on
-
Enough fuel
-
Remove the usb stick until its led stops blinking completely
It is possible to perform a recovery of the unit by inserting again a valid DMUP usb stick; this will restart the
update process, recovering the TEB software from this state, making it fully functional again.
Further Tips
It is recommended to use the official USB stick. If a different USB is used, please verify that is without invalid
sectors, correctly formatted (FAT32) and with a led (light emitting diode) to indicate activity of the usb stick
during the DMUP process; until this led stops blinking completely, this can be removed safely.
Even if the DA does not shows any activity, if the usb stick shows activity do not remove it until this stops
blinking completely.
Note
If the DMUP cannot be completed, please provide also the usb stick for further analysis.
Top page
How to access the Service Menu
How to check DTC codes
Insert the USB with
the Map Update
Software
How to Identify T2wG and Device
How to access the Repair Manual
How to install latest softwares
ID
NG Techdoc
Unknown issue
DA
DA & Ext. Box
Advertisement
