Advertisement
3- Touch2 plays only one song from USB stick
Phenomenon Description:
When music is played by USB plat list, the system shows all tracks saved on USB stick. If the
customer change source (to BT, AM, FM, USB) or switch ACC OFF/ON, the system continue to
play the current track, but shows less number of tracks (1 track only).
If the customer tried to change the tracks used buttons UP and DOWN, the system switched
only between the track which shown on the display (current situation 1 of 1 track).
For using all tracks from USB stick, the customer needs to push overview button on the touch
screen, then choose any track from the list -> system again recognized all tracks on USB stick.
Supplier: Fujitsu Ten / Denso Ten
This phenomenon can occur on the following vehicles (see table) on DA software lower than
mentioned in below table.
The problem has been resolved as from the software version shown below table or higher.
Camry, depends which DA-unit type fitted
How to fix:
Install latest released DA Software. (See hyperlink on the bottom of the page)
Top page
How to access the Service Menu
How to check DTC codes
Vehicle Model
Hilux
Verso S
Yaris
Alphard
Hilux MY2015
C-HR
How to Identify T2wG and Device
How to access the Repair Manual
How to install latest softwares
Minimum Required Software Version
FE3063
FE3063
XE3934
XE3934
XE3934
GE3934 / VE3934
VE3934
ID
NG Techdoc
Unknown issue
DA
DA & Ext. Box
Advertisement
