Advertisement
2- Black screen immediately after ignition on
Phenomenon description:
The phenomenon is triggered under the following conditions:
Ignition off was performed with the gear in reverse and the rear camera is displayed.
For example: customer is parking in reverse into a parking spot and switches off the engine
without taking the car out of reverse gear.
Supplier: Fujitsu Ten / Denso Ten
This phenomenon can occur on the following vehicles (see table) on DA software lower than
mentioned in below table.
The problem has been resolved as from the software version shown below table or higher.
Camry, depends which DA-unit type fitted
How to fix:
Install latest released DA Software. (See hyperlink on the bottom of the page)
Top page
How to access the Service Menu
How to check DTC codes
Vehicle Model
Hilux
Verso S
Yaris
Alphard
Hilux MY2015
C-HR
How to Identify T2wG and Device
How to access the Repair Manual
How to install latest softwares
Minimum Required Software Version
FE3063
FE3063
XE3934
XE3934
XE3934
GE3934 / VE3934
VE3934
ID
NG Techdoc
Unknown issue
DA
DA & Ext. Box
Advertisement
