Advertisement
2- The voice guidance is set to a high volume during a handsfree phonecall
Phenomenon description:
When there is an active phone call via Bluetooth HF, the volume of the navigation voice
guidance goes to MAXIMUM even when navigation volume is set a lower level in the setup
menu.
During this HIGH volume navigation command, the customer could not hear his phone call.
When the phone call is stopped, the voice guidance volume is much lower.
Supplier: Fujitsu Ten / Denso Ten
This phenomenon can occur on the following vehicles (see table) on DA software lower than
mentioned in below table.
The problem has been resolved as from the software version shown below table or higher.
Camry, depends which DA-unit type fitted
How to fix:
Install latest released DA Software. (See hyperlink on the bottom of the page)
Top page
How to access the Service Menu
How to check DTC codes
Vehicle Model
Hilux
Verso S
Yaris
Alphard
Hilux MY2015
C-HR
How to Identify T2wG and Device
How to access the Repair Manual
How to install latest softwares
Minimum Required Software Version
FE3063
FE3063
XE3934
XE3934
XE3934
GE3934 / VE3934
VE3934
ID
NG Techdoc
Unknown issue
DA
DA & Ext. Box
Advertisement
