Base Assembly; How To Remove The Base - Genie SUPERLIFT Contractor SLC-6 Parts & Service Manual

Section 6 - Repair Procedures
Base Assembly
1-1
How to Remove the Base
1 Fully lower the carriage.
2 Remove the load handling attachment from the
machine.
Machines with stabilizers:
3 Remove the mounting fasteners from the
stabilizer mounting bracket on the back of the
mast.
4 Remove the mounting fastener from each of
the stabilizers at the base. Remove the
stabilizers from the machine.
All Models:
5 Using proper lifting techniques, tilt the machine
back and rest the
loading wheels
against a sawhorse or
other suitable support.
6 Remove the mounting
fastener and retaining
pin from each leg.
Then remove the legs from the machine.
7 Using proper lifting techniques, tilt the machine
to the upright position.
8 Attach an overhead crane to the lifting bracket
on the number 1 mast.
9 Place a sawhorse on the carriage side of the
mast.
Parts and Service Manual - First Edition
1 0 Lift the machine slightly and then while lowering
it, guide the machine over onto the sawhorse.
r
Crushing hazard. The machine
: will fall unless it is properly
supported with the overhead
crane.
11 Secure the top of the mast to the sawhorse.
12 Attach an overhead crane to the· base and lift
the machine enough to slide a second
sawhorse under the mast, next to the base.
' Crushing hazard. The machine
, : will fall unless it is properly
supported with the overhead
crane.
13 Remove the mounting fasteners from the mast
brace to the base. Repeat for other side.
14 Remove the base mounting fasteners. Then
remove the base from the machine.
6-2 Genie Superlift Contractor
Part No. 33953