Assembly And Disassembly - Genie Super-Straddle Operator's Manual

Third Edition • First Printing
Ass embly and Disas sem bly

Assembly and Disassembly

To move the Super-Straddle through a doorway or
to set it up after shipping, follow these instructions.

Assemble or disassemble the Super-Straddle
only on a firm, level surface.

Two people are required to safely maneuver
and support the Super-Straddle components
through this procedure.

Do not allow Super-Straddle components to
drop.
1 telescoping tube
2 washer
3 bolt
4 end frame
5 wear pad
6 wing nut
Part No. 1298031GT
Assembly and Disassembly
Assembly
1 Apply the caster brakes. Set the caster swivel
locks parallel to the straddle platform tubes.
2 Both winch cables must be fully lowered.
3 Be sure that the telescoping tubes are inserted
and pinned to the same length in the straddle
platform.
4 Move the end frame
marked Base Frame
(refer to decal on
base frame) to the
end of the straddle
platform nearest the
cross member.
5 One person must support the end frame while
the other attaches it to the straddle platform.
The winch handle should point away from the
machine.
6 Position the wear pads and attach each one
with the supplied bolts, washers and wing
nuts.
7 Move the end frame
marked Telescoping
Base Frame (refer to
decal on telescoping
base frame) to the
other end of the
straddle platform and
repeat steps 5 and 6.
8 Make sure all wing nuts are tight.
9 Connect the electrical cords.
Super-Straddle
Operator's Manual
9