6A-9. Lens Home Position Sensor Adjustment
[FT3050/FT3060]
NOTE: When the lens home position sensor is rep-
laced or when horizontal magnification
and/or a focus will not improve by adjusting
the wire clamp, do this adjustment.
1.
Remove the exposure glass (4 screws), the
lens housing cover (3 screws), and the rear
cover (2 screws).
2.
By turning the lens drive gear, move the lens
from left to right until it reaches the full size
position.
At the full size position, a line through the
center of the cam follower and the first align-
ment hole will form a right angle with a line
through the center of the first and second
alignment holes.
July 1, '85
6-10-e