Table of Contents
Advertisement
4.
When a new cleaning blade, a new cleaning
brush, and/or new cleaning side seals are
installed, dust them with setting powder
before reinstalling the unit.
5.
Toner collected from the cleaning unit can not
be used again.
6.
Do not adjust the blade stopper screw.
Fusing
1.
After replacement of the oil blade, oil supply
pad, felt wick and the hot roller, prime with
silicone oil to the top of the oil blade.
2.
Be careful not to damage the edge of the hot
roller strippers or their tension springs.
3 .
Be careful not to bend the pressure roller strip-
pers.
4.
Do not touch the fusing lamp with bare hands.
5.
Be sure that the fusing lamp is not in contact
with the inner surface of the hot roller.
Paper Feed and Clutches
1. Grease the following parts with Mobil Temp.
78 periodically to avoid noise and bad opera-
tion:
a. Slip Clutch
b. Paper Feed Clutch
Registration Clutch
c.
d. Toner Supply Clutch
2. Periodically lubricate the paper lift motor
worm gear and worm wheel with Launa oil or
an equivalent oil.
5-3
Advertisement
Chapters
Table of Contents
