Toro 110-2626 Installation Instructions Manual page 15

3. Install the 45° of the hydraulic supply hose to the
straight fitting in port B of the hydraulic control
manifold (Figure 31).
1. Straight fitting (port
B—extend)
2. Hydraulic control manifold
3. 45° hydraulic fitting (port
A—retract)
4. Install the 45° fitting of the hydraulic supply hose to
the 90° hydraulic fitting in port B (retract) of the lift
cylinder control valve
5. Route the hose along the other hose
you routed in step 2.
6. Install the straight fitting of the hydraulic supply hose
to the 45° hydraulic fitting in port A of the hydraulic
control manifold (Figure
7. Secure the hoses to the chassis with cable ties as
required to support the hoses and prevent interference
with moving parts of the machine.
Installing the Hoses (HDX-Auto
Workman models)
1. Install the straight fitting of the hydraulic supply hose
to the straight fitting in port A (extend) of the lift
cylinder control valve
Figure 31
4. Back of the machine
5. Hydraulic supply hose
(straight fitting—retract)
6. Hydraulic supply hose (45°
fitting—extend)
(Figure 29).
(Figure
31).
(Figure 32).
1. Lift cylinder control valve
2. Straight fitting (Port
A—extend)
3. Hydraulic supply hose
(straight fitting)
2. Route the hose along the right side of the machine
along the path of the 2 hydraulic tubes
you removed in
(page
30) that
1. Hydraulic supply hose
(extend)
2. Hydraulic supply hose
(retract)
3. Install the 45° fitting of the hydraulic supply hose to
the 45° hydraulic fitting in port B (retract) of the lift
cylinder control valve
15
Figure 32
4. Front of the machine
5. 90° hydraulic fitting (Port
B—retract)
6. Hydraulic supply hose (45°
fitting)
5 Removing the Hydraulic Lift Lines
8).
Figure 33
3. Front of the machine
(Figure 34).
(Figure 33) that