Table of Contents
Advertisement
Figure 40
1. Switch
3. Connect the 8-socket connector to the blade connector
of the 3-position switch.
4. Align the window for the indicator light in the
3-position switch up.
5. Insert the 3-position switch into the hole dash panel
until the switch snaps securely into position
6. Affix the decal to the dash panel, next to the switch
(Figure
40).
7. Secure the wiring harness to the chassis with cable
ties as required to support the wiring harness and to
prevent interference with moving parts of the machine.
14
Installing the Hydraulic Lift
Lever Neutral Switch
Parts needed for this procedure:
1
Neutral switch
1
Locknut (10-24 inch)
1
Carriage bolt (10-24 x 5/8 inch)
1
Switch plate
Procedure
Installation of the hydraulic lift lever neutral switch pertain
to Workman models that do not have the hydraulic lift lever
neutral switch installed. If your machine is already equipped
with a hydraulic lift lever neutral switch, skip to
the Seat Shroud and ROP Shield (HD and HDX series
models), and Coolant Tank (non-HD models) (page
1. Insert the new neutral switch into the slot in the left
rear corner of the control console frame and position
the switch as shown in
Note: A different neutral switch (Toro Part No.
105-0023) is required if your HD series Workman has
1
2
G010463
2. Decal
(Figure
15 Installing
20).
Figure
41.
a serial number is in the range of 240000000 thru
249999999.
1. Slot (control console
frame)
40)
2. Switch plate
2. Loosely secure the switch in the console slot
41) with a switch plate, carriage bolt (10-24 x 5/8 inch)
and locknut (10-24 inch).
Note: Make sure that the tab of the switch plate
passes thru the slot and into the other hole in the
neutral switch.
3. In the same area of the control console, locate the 2
connectors and jumper wires coming from the main
wire harness of the machine.
4. Remove one of the jumper wires and plug that
connector of the main wire harness into the connector
for the neutral switch.
5. Adjust the position of the switch (forward or backward)
until the target on the switch is aligned with the rod for
the lift-cylinder control valve.
6. Tighten the carriage bolt and locknut to secure the
position of the neutral switch
7. Install the terminal of the positive battery cable to the
battery post; refer to
(page
4).
8. Align the battery cover to the battery base, squeeze the
cover, and insert the tabs of the cover into the slots
in the battery base; refer to
Kit (page
4).
9. Check the adjustment of the neutral switch as follows:
A. Ensure that the parking brake is set and
tranasmission shift lever is in Neutral
(non-HDX-Auto Workman models) or Park
(HDX-Auto Workman models).
B. Move the hydraulic lift lever forward to the lower
position and try to start the engine.
19
Figure 41
3. Carriage bolt (10-24 x 5/8
inch)
4. Neutral switch
(Figure
41).
1 Preparing to Install the Kit
1 Preparing to Install the
(Figure
Advertisement
Table of Contents
