Table of Contents
Advertisement
Figure 19
1. Port B (hydraulic control
manifold)
2. Straight hydraulic fitting
B. Install a 45° hydraulic fitting into port A of
the hydraulic control manifold
2. Install 90° hydraulic fittings into ports C1 and C2 of the
hydraulic control manifold
Note: Align the fittings as shown in
Figure
23.
Figure 20
1. 90° hydraulic fitting
2. Port C1 (hydraulic control
manifold)
3. Install 2 new straight fittings (9/16 x 9/16 x 3/8 inch)
into ports C3 and C4
3. Port A (hydraulic control
manifold)
4. 45°hydraulic fitting
(Figure
(Figure 20
and
Figure
Figure 20
3. Port C2 (hydraulic control
manifold)
(Figure
21).
1. Female quick disconnect
coupling
2. Straight fittings (9/16 x
9/16 x 3/8 inch—new)
3. Port C4 (hydraulic control
manifold)
19).
4. Install the male quick disconnect coupling that you
removed in step
23).
Bracket (page 10)
and
(9/16 x 9/16 x 3/8 inch) in port C3
5. Install the female quick disconnect coupling that you
removed in step
Bracket (page 10)
(9/16 x 9/16 x 3/8 inch) in port C4
(HDX-Auto Workman models)
Note: Ensure that the O-rings are installed on the fittings
and lubricated with hydraulic fluid from the machine before
installing the fittings into the manifold.
1. Install a 45°hydraulic fitting into port B of the hydraulic
control manifold
1. Port B (hydraulic control
manifold)
2. 45°hydraulic fitting
2. Install a 90° hydraulic fitting into port A of the
hydraulic control manifold
3. Install 90° hydraulic fittings into ports C1 and C2 of
the hydraulic control manifold as shown in
11
Figure 21
4. Male quick disconnect
coupling
5. Port C3 (hydraulic control
manifold)
3
of
Removing the Quick Disconnect
onto the straight hydraulic fittings
(Figure
3
of
Removing the Quick Disconnect
onto the straight hydraulic fittings
(Figure
(Figure
22).
Figure 22
3. Port A (hydraulic control
manifold)
4. 90° hydraulic fitting
(Figure
22).
21).
21).
Figure
23.
Advertisement
Table of Contents
