Toro 110-2626 Installation Instructions Manual page 9

1. Front of the machine
2. Lift cylinder control valve
4. Remove the tubes from the machine.
Note: Discard the tubes.
6
Removing the Quick
Disconnect Hose Fittings
and the Quick Disconnect
Bracket
No Parts Required
Removing the Quick Disconnect Hose
Fittings
1. Align drain pan under the fittings at the quick
disconnect bracket at the right rear of the machine
(Figure 16).
Figure 15
3. Tube (lift cylinder—retract
circuit)
4. Tube (lift cylinder—extend
circuit)
1. Quick disconnect bracket
2. Quick disconnect fitting
(male—retract circuit)
2. Remove the 2 lift cylinder hoses from the quick
disconnect bracket
3. Remove the 90° fittings and the quick disconnect
fittings from the end of the 2 lift cylinder hoses
16).
Note: Temporarily install a plug into the end of each
hose.
9
Figure 16
3. Quick disconnect fitting
(female—extend circuit)
(Figure 16).
(Figure