Table of Contents
Advertisement
Figure 23
1. 90° hydraulic fitting
2. Port C1 (hydraulic control
manifold)
4. Install 2 new straight fittings (9/16 x 9/16 x 3/8 inch)
into ports C3 and C4
Figure 24
1. Female quick disconnect
coupling
2. Straight fittings (9/16 x
9/16 x 3/8 inch—new)
3. Port C4 (hydraulic control
manifold)
5. Install the male quick disconnect coupling that you
removed in step
3
of
Bracket (page 10)
onto the straight hydraulic fittings
(9/16 x 9/16 x 3/8 inch) in port C3
6. Install the female quick disconnect coupling that you
removed in step
3
of
Bracket (page 10)
onto the straight hydraulic fittings
(9/16 x 9/16 x 3/8 inch) in port C4
3. Port C2 (hydraulic control
manifold)
(Figure
24).
4. Male quick disconnect
coupling
5. Port C3 (hydraulic control
manifold)
Removing the Quick Disconnect
(Figure
24).
Removing the Quick Disconnect
(Figure
24).
8
Installing the Manifold Bracket
and Hydraulic Control Manifold
Parts needed for this procedure:
1
Flat manifold bracket
Flanged manifold bracket (HDX-Auto Workman
1
models)
2
Bolt (5/16 x 3/4 inch)
2
Lock washer (5/16 inch)
Install the Manifold Bracket
(non-HDX-Auto Workman models)
1. Align the holes in the flat manifold bracket to the holes
in the flange of the transaxle support
1. Flanged-head bolt
2. Transaxle support
2. Secure the bracket to the support with the 2
flanged-head bolts and 2 flanged locknuts
that you removed in step
Disconnect Bracket (page
12
(Figure
Figure 25
3. Manifold bracket
4. Flanged locknut
(Figure
1
of
Removing the Quick
10).
25).
25)
Advertisement
Table of Contents
