Advertisement
Quick Links
Glove Box Cover Kit
Workman
Model No. 137-2883
This product contains a chemical or chemicals known to the State of California
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface and engage
the parking brake; ensure that the traction pedal
is in the neutral position.
2.
Shut off the engine and remove the key.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
GTX Utility Vehicle
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
Description
No parts required
Glove box cover
Latch assembly
Thumb pull
Lock washer
Nut
Hinge
Rivets
Foam strip
Strike plate
Bolt
Hex nut
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
1
1
1
1
1
1
6
1
1
2
2
CAUTION
If you leave the key in the ignition
switch, someone could accidently start
the engine and seriously injure you or
bystanders.
Remove the key from the switch before
you do any maintenance.
Form No. 3419-183 Rev A
Installation Instructions
Use
Prepare the machine.
Install the hinge and cover.
Install the strike plate.
Original Instructions (EN)
All Rights Reserved *3419-183* A
Printed in the USA
Advertisement
Related Manuals for Toro Workman 137-2883
Summary of Contents for Toro Workman 137-2883
- Page 1 Park the machine on a level surface and engage the parking brake; ensure that the traction pedal is in the neutral position. Shut off the engine and remove the key. © 2017—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3419-183* A...
- Page 2 Installing the Hinge and Cover Parts needed for this procedure: Glove box cover Latch assembly g233663 Figure 2 Thumb pull Lock washer Align the glove box cover to the glove box; using the bottom of the hinge as a template, mark the Hinge location of the center and outer holes on the Rivets...
- Page 3 Install the Strike Plate Parts needed for this procedure: Strike plate Bolt g233793 Hex nut Figure 5 1. Back of glove box 3. Nut Procedure 2. Screw Close the glove box cover, and mark the location of the notch at the top of the glove box. Note: You may also remove the dash reinforcement to improve clearance.