Table of Contents
Advertisement
Removing the Quick Disconnect
Bracket
1. Remove the 2 flanged head bolts and 2 flanged locknuts
that secure the quick disconnect bracket to the flange
of the transmission support of the machine
Note: Retain the flanged head bolt and flanged
locknut for installation of the manifold bracket in
Installing the Manifold Bracket and Hydraulic Control
Manifold (page
12).
Figure 17
1. Flanged head bolt
2. Quick disconnect bracket
2. Remove the bracket from the machine
3. Remove the straight fittings and the quick disconnect
coupling from the quick disconnect bracket.
Note: Retain the male and female quick disconnect
couplings and straight fittings; discard the bracket.
(Figure
8
3. Flanged head nut
(Figure
17).
7
Preparing the Hydraulic
17)
Control Manifold
Parts needed for this procedure:
1
Hydraulic control manifold
1
Straight hydraulic fitting (11/16 x 9/16 x 3/8 inch)
1
45° hydraulic fitting
3
90° hydraulic fitting
2
Straight hydraulic fittings (9/16 x 9/16 x 3/8 inch)
Preparing the Hydraulic Control
Manifold (non-HDX-Auto Workman
models)
Note: Ensure that the O-rings are installed on the fittings
and lubricated with hydraulic fluid from the machine before
installing the fittings into the manifold.
1. Install the A and B port fittings into the manifold as
follows:
•
For 2000 and 3000 series Workman
Install the 2 straight hydraulic fitting that you
removed in step
Disconnect Bracket (page 10)
of the maniflod
1. Port B (hydraulic control
manifold)
2. Straight hydraulic fitting
•
For HD, HDX, and HDX-D Workman
A. Install 1 of the straight hydraulic fittings that
you removed in step
Disconnect Bracket (page 10)
the hydraulic control manifold
10
3
of
Removing the Quick
into ports A and B
(Figure
18).
Figure 18
3. Port A (hydraulic control
manifold)
3
of
Removing the Quick
into port B of
(Figure
19).
Advertisement
Table of Contents
