Toro 127-7377 Installation Instructions

Splash guard kit 2010 and after workman md or mdx utility vehicle

Download this manual

Splash Guard Kit

2010 and After Workman

Model No. 127-7377

This product contains a chemical or chemicals known to the State of California to

Installing the Air-cleaner

Shield

1. Using the air-cleaner shield as the template, drill 3 holes

(4.8 mm (3/16 inch) in diameter) into the engine tray

(Figure 1).

1. Engine tray

2. Align the air-cleaner shield with the 3 holes in the

engine tray.

8111 Lyndale Avenue South

Bloomington, MN 55420

Proposition 65 Warning

cause cancer, birth defects, or reproductive harm.

Figure 1

2. Air-cleaner shield

MD or MDX Utility Vehicle

WARNING

CALIFORNIA

3. Secure the air-cleaner shield to the engine tray with 3

tek screws (1/4 inch) as shown in Figure 2.

1. Engine tray

2. Air-cleaner shield

Form No. 3382-204 Rev A

Installation Instructions

Figure 2

3. Tek screws (1/4 inch)

Original Instructions (EN)

Printed in the USA

Page 1 Form No. 3382-204 Rev A Splash Guard Kit 2010 and After Workman ® MD or MDX Utility Vehicle Model No. 127-7377 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Page 2 Installing the Clutch Shield 1. Using the clutch shield as the template, drill 4 holes (4.8 mm (3/16 inch) in diameter) into the engine tray (Figure 3). Figure 3 1. Engine tray 2. Clutch shield 2. Align the clutch shield with the 4 holes in the engine tray.