Toro 131-8308 Installation Instructions

Solenoid Controller Kit
Workman
Model No. 131-8308
This product contains a chemical or chemicals known to the State of California to
The purpose of this kit is ad add a solenoid controller
to the electrical system. The solenoid controller is used
to automatically modulate the current to the differential
solenoid.
Preparing to Install the Kit
1. Move the machine to a level surface and set the parking
brake.
2. For machine models with a utility bed, perform the
following:
A. Raise the bed until the lift cylinders are fully
extended; refer to the Operator's Manual for the
machine.
B. Remove the bed support from the storage
brackets on back of the ROPS panel
1. Bed Support
C. Place the bed support onto the cylinder rod,
making sure that the support end tabs rest on the
end of cylinder barrel and on the cylinder rod end
(Figure 2).
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® HDX-Auto Utility Vehicle
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
(Figure
Figure 1
Register at www.Toro.com.
WARNING
CALIFORNIA
1).
1. Bed support
2. Cylinder barrel
3. Shut off the engine, set the parking brake, and remove
the key from the ignition switch.
4. Disconnect the battery as follows:
A. Squeeze the battery cover to release the tabs from
battery base
Form No. 3390-719 Rev A
Installation Instructions
Figure 2
3. Bed
(Figure 3).
Original Instructions (EN) All Rights Reserved *3390-719* A
Printed in the USA