Huawei UA5000 Manual page 155

UA5000 Universal Access Unit
Environment Monitoring
15. Query the alarms, and confirm that the door status alarm other than alarms for other
16. Save the data.
17. Close all doors of the cabinet. Then, query the alarm information again, and confirm that
Issue 01 (2012-08-17)
0
6 MDF-door
0
----------------------------------------------------------------------------
monitoring parameters is generated.
huawei(config-if-power4875l-0)#display power alarm
EMU ID: 0
----------------------------------------------------------------------------
Mains supply yes : Yes
Total Vol lack : Normal
Load fuse 0 : Connect
Load off : On
Battery 0 loop : Disconnect
Environment Temperature : Normal
Door alarm : Alarm
Fog alarm : Normal
Module 0 : Normal
Module 1 : Normal
Module 2 : Normal
Battery temperature off state : Normal
----------------------------------------------------------------------------
Name
Spare Dig0(Fan)
Normal
Spare Dig2
Normal
Spare Dig4(Smoke)
Spare Dig6(MDF-door)
----------------------------------------------------------------------------
NOTE
The door status sensors of the device compartment and the temperature control compartment are in
serial connection, and are monitored as a variable. These two door status sensors are automatically
configured by the system. The door status alarm is generated because the door is open.
huawei(config-if-power4875l-0)#quit
huawei(config)#save
there is no alarm for any monitoring parameter.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 ETP4890 Monitoring Solution
Power alarm information
Mains supply lack : Normal
Second fuse : Connect
Battery off : On
Environment Humidity
Water alarm : Normal
Wiring alarm : Normal
Load temperature off state : Normal
State |Name
Normal|Spare(HABF_FAN)
Normal|Spare Dig3(SPD)
Normal|Spare Dig5(HEX)
Alarm
: Normal
State
Alarm
149