Installation Instructions - Siemens SINUMERIK 840DiE sl Manual

01/2007
2.3.2

Installation instructions

Installing
the module
!
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
The connecting cable with the MCI board is part of the scope of supply and is
already plugged into the MCI board extension slot variation.
To install the module, proceed in the sequence described below.
Warning
Operating electrical equipment has parts and components that are at
hazardous voltage levels.
Failure to properly maintain the equipment can result in death, serious bodily
injury or substantial material damage.
When servicing these devices, you should therefore observe all notices
provided in this section and attached to the product itself.
– This device may only be serviced by appropriately qualified personnel.
– Before starting any maintenance and service work, disconnect the device
from power supply.
– Use authorized spare parts only.
– Strictly observe the prescribed maintenance intervals, as well as the
instructions for repair and replacement.
Notice
The module contains electrostatically sensitive devices.
Electrostatically discharge your own body before touching the module. The
simplest way of doing this is to touch an electrically conductive grounded object
(e.g. a bare metal part of a cabinet or a power receptacle ground conductor).
1. Shut down the SINUMERIK 840Di sl and Windows XP correctly.
Use one of the following methods to do this:
S
Windows XP taskbar: Start > Shut Down
S
Interface signal: "PC shutdown", see Section 18.1.1, Page 18-499
2. Disconnect your PC from power supply.
3. Remove the screws from the cover of the housing (Fig. 2-8) and open the
housing of your PC, observing the relevant safety regulations.
2 Hardware Descriptions
2.3 MCI board extension slot variant
2-55