Dp Slave: Mcp 310 - Siemens SINUMERIK 840DiE sl Manual

01/2007
8.6

DP slave: MCP 310

8.6.1 General conditions for commissioning
Hardware
Software
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Fig. 8-10 MCP 310 front panel
The following hardware is required:
S
PROFIBUS connecting cable
No terminating resistor is integrated in the machine control panel.
The following software is required:
S
PLC basic program
The relevant modules of the basic PLC program are FB 1 (MCP commu-
nication parameters), FC 19 (interface parameter assignment version: mill-
ing) and FC 25 (interface parameter assignment, version: turning).
The library of the PLC basic program is part of the SINUMERIK 840Di sl.
How to install the library is described in Section 6.4, Page 6-152.
S
SIMATIC STEP 7
SIMATIC STEP 7 is needed to customize the PLC basic and user programs
to the requirements of the respective automation system. SIMATIC STEP7
can be installed directly on the PCU of the SINUMERIK 840Di sl. How to
install additional software is described in Section 17, Page 17-477.
S
DP slave: MCP 310
The DP slave: MCP 310 is part of the PLC Toolbox. When the PLC Toolbox
is installed, it is automatically installed in SIMATIC STEP 7.
Note
The PLC basic program must be installed on the computer on which SIMATIC
STEP 7 is installed. For installing the PLC basic program, please observe the
appropriate notes in the file:
S
<Installation path>\importantinfo.rtf
8 PROFIBUS DP Communication
8.6 DP slave: MCP 310
8-195