Dp Slave: Adi4 - Siemens SINUMERIK 840DiE sl Manual

8 PROFIBUS DP Communication

8.8 DP slave: ADI4

8.8 DP slave: ADI4
8.8.1 Slave OM
8.8.2 Inserting DP slave
References
8-222
Notice
The ADI4 DP slave can only be operated on an isochronous PROFIBUS DP.
Parameters for the configuration with regard to the ADI4 interface modules,
called DP slave ADI4 here, are assigned with the SlaveOM for SINUMERIK
840Di sl. For how to install the slaveOM, see below: References.
Note
To simplify parameterization of the isochronous communication on the
PROFIBUS DP, you must first insert all the DP slaves (drives, ADI4, I/O
modules, etc.) you require into the configuration before parameterization of the
DP drives, before you set the times for isochronous communication.
To insert an ADI4 DP slave in the configuration, open the hardware catalog us-
ing the View > Catalog menu command.
The DP slave ADI4 is to be found at:
S
Profile: Default
PROFIBUS DP > SINUMERIK > ADI4
Select DP slave ADI4 by clicking it with the left mouse button and drag it to the
DP master system in the Station window holding down the mouse button.
The DP master system is displayed in the station window with the following
symbol:
When you release the left mouse button, the DP slave ADI4 is inserted into the
configuration.
Note
Make sure that the cursor, which appears as a crossed–out circle when
dragging the DP slave, is positioned exactly on the DP master system so that
the DP slave is inserted into the configuration.
For a complete description of the parameterization of an AD14 DP slave please
refer to:
References: /ADI4/ Analog drive interface for four axes
Section: Parameterization
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007