Configuring The Dp Slave: Mcp 310 - Siemens SINUMERIK 840DiE sl Manual

8 PROFIBUS DP Communication
8.6 DP slave: MCP 310
8.6.4

Configuring the DP slave: MCP 310

HW Config – [SINUMERIK840D (configuration) –– PROFIBUS MCP]
Station Edit Insert Target System View Tools Window Help
(0) 810D/840D
2
PLC 317–2DP 2AJ10
X1 MPI
X2
DP
IM 360
3
4 S7 FM NCU
PROFIBUS(1): DP master system(1)
Slot DP ID
1
55
2
2IO
3 192
Fig. 8-14 Configuration with DP slave: MCP 310
Preconditions: S7
project
Inserting the DP
slave
8-200
This section describes the configuration of a DP slave: MCP 310 by way of ex-
ample of the configuration of a SIMATIC S7 project shown in Fig. 8-14.
The configuration comprises the following modules:
S
SIMATIC Station 300 with SINUMERIK 810D/840D and PLC 317–2DP
S
SINUMERIK MCP with module: standard, handwheel, extended
To configure DP slave: MCP 310 the following steps must be carried out in the
S7 project:
1. Insert DP slave: MCP 310 in the configuration
(see Fig. 8-14, Page 8-200: 1)
2. Set the PROFIBUS address.
3. Insert the modules in DP slave: MCP 310 for the functions required.
(see Fig. 8-14, Page 8-200: 2)
4. Set the I/O addresses for the individual slots.
PROFIBUS(1): DP master system(1)
(9) SINUME
Order number/designation
standard, handwheel, extended 0...7
––> standard, handwheel, exten 258...261
––> standard, handwheel, exten 8...12
The following status of the S7 project into which DP–Slave: MCP 310 is to be
inserted is assumed:
– You have created the S7 project
– You have set up a SIMATIC 300 station with PROFIBUS master–capable
SINUMERIK controller
To insert a DP slave: MCP 310 into the configuration, open the hardware cata-
log with menu item View > Catalog.
Profile:
1
2
I address O address Com...
0...7
8...9
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007
Default
I/O
NC/RC
MOTION CONTROL
SINUMERIK MCP
Universal module
standard
standard, handwheel
standard, extended
standard, handwheel, ex