Test Run - Grizzly G0767 Owner's Manual

16. Remove the two pre-installed vise mounting
cap screws shown in Figure 15.
Vise
Mount
Figure 15. Vise mounting cap screws.
17. Position vise assembly on vise mount and
secure it with cap screws removed in Step 16
(see Figure 16).
Cap Screws
Figure 16. Vise assembly attached.
18. Slide spark trap into grooves on right side of
machine, as shown in Figure 17.
Spark Trap
Figure 17. Spark trap positioned in grooves.
-18-
Cap
Screws
Grooves

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Model G0767 (Mfd. Since 1/14)