Deburring - Grizzly G0767 Owner's Manual

Deburring

Sharp burrs in the tube are typically created dur-
ing notching. These should be ground off for safe
handling and clean welds during tubing.
To deburr notched tubing:
1.
Put on PPE.
PERSONAL PROTECTIVE
EQUIPMENT (PPE)
The Model G0767 produces a large amount
of sparks that can cause burns and injuries
to skin, eyes, and face. ALWAYS wear safety
goggles, face shield, dust mask, heavy
leather, long sleeve gloves, and leather
apron to reduce the risk of injury from flying
sparks when operating. Also, wear leather
boots with toe protection to reduce risk of
injury from a falling tube.
2.
Open deburring station cover to expose abra-
sive belt.
3. Stand to side of machine and turn machine
ON, then wait until abrasive belt reaches full
speed.
Note: Abrasive belt travels towards front of
machine at the deburring station.
Model G0767 (Mfd. Since 1/14)
4. Position tube at a slight angle to abrasive belt
(see Figure 34) and make light contact with
belt. Rotate tube to deburr entire circumfer-
ence of notched end.
Figure 34. Tube positioned for deburring.
5. When finished, turn machine OFF, wait for
abrasive belt to completely stop, and close
deburring station cover.
-27-