Table of Contents
Advertisement
6.
Loosen vise cap screws shown in Figure 29.
Cap
Screws
Angle Scale
Figure 29. Vise angle controls.
7.
Using angle scale, rotate vise to desired
angle of notch (from 90° to 30° in relation to
front profile roller), then retighten both cap
screws.
8.
Use crank handle (see Figure 30) to adjust
space between clamp plate and jaws to
accept tube.
Spark Shield Lock Handle
Jaws
Clamp
Plate
Figure 30. Vise clamping controls.
When mounting tubes longer than 3', have
another person support end of tube. This
will reduce risk of tube unexpectedly coming
loose in vise during operation and causing
impact injuries or property damage.
Model G0767 (Mfd. Since 1/14)
Crank
Handle
Clamp Lever
In next step, make sure tube end you plan
to notch is protruding far enough out of
vise that vise will not contact belt during
operation. Otherwise, property damage
may occur.
9.
Insert tube between jaws and clamp plate
(see Figure 31), making sure tube extends
far enough that notching operation can be
performed without vise contacting belt.
Figure 31. Tube inserted in vise.
10. Loosen clamp lever (Figure 30), then use
crank handle to position clamp plate within
⁄
" of tube.
1
16
11. Tighten clamp lever to lock tube in place.
Note: If it is too difficult to secure tube with
clamp lever, use crank handle to slightly
increase distance between clamp plate and
tube, then try again.
12. Position spark shield over profile roller and
lock it in place (see Figure 30).
-25-
Advertisement
Table of Contents
