Table of Contents
Advertisement
6.
Center belt on drive pulley.
7.
Without holding abrasive belt lever, push
motor back with moderate force until it stops.
This applies correct abrasive belt tension.
8.
Perform Abrasive Belt Tracking procedure
on next page.
-22-
Replacing Profile
Roller
The Model G0767 includes seven profile rollers
ranging from
⁄
" to 3". The size of profile roller
3
4
you use will depend on the size of tubing your
workpiece will be welded to.
To install profile roller:
1.
DISCONNECT MACHINE FROM POWER!
2.
With abrasive belt removed, remove profile
roller from support bracket (see Figure 24).
Profile
Roller
Figure 24. 1" profile roller installed.
3.
Thoroughly clean all surfaces of profile roller
with sop rag and mineral spirits, then apply a
light coat of rust preventative before placing
roller in storage cabinet.
4.
Repeat Step 3 with desired profile roller to be
installed.
5.
Place desired profile roller in support bracket
and install abrasive belt.
Model G0767 (Mfd. Since 1/14)
Support
Bracket
Advertisement
Table of Contents
