Applying Thermal Paste - Fujitsu PRIMERGY TX1310 M3 Upgrade And Maintenance Manual

11.2.5 Applying thermal paste

I
For Japan, the service engineer must follow the instruction provided
separately.
I
If the CPU upgrade or replacement kit contains a new CPU heat sink, a
thin layer of thermal compound has already been pre-applied to its lower
surface. In this case, please proceed with section
sink" on page
Figure 76: Thermal paste syringe
One thermal compound syringe (FTS-FSP:P304000004) contains thermal
paste for three CPUs.
In order to determine the correct amount of thermal paste (equal to 1.0 gram),
divide the grey area of the syringe up into three equal segments.
I
Add graduation marks to the syringe using a permanent marker to help
you apply the thermal paste.
TX1310 M3
143.
Upgrade and Maintenance Manual
Processor (CPU)
"Installing the heat
141