Information Messages - Flymo EasiLife 200 Operator's Manual

6.3 Information messages

The information messages in the table below are shown in the display of the product. Speak to your
Flymo customer service if the same message shows frequently.
Message Cause
Low battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
The charging plates on the product or
contact plates on the charging station
are corroded.
Settings restored
Confirmation that a
tings has been carried out.
Guide not found
The guide wire is not connected to the
charging station.
Break in the guide wire.
The guide wire is not connected to the
boundary loop.
Guide calibration
The product has failed to calibrate the
failed
guide wire.
44 - Troubleshooting
Action
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 21 .
Check that the guide wire is connected
to the charging station correctly. Find
out where the break is and rectify it.
Replace the battery. Refer to
on page 36 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 45 .
Clean the charging and contact plates
using a fine grade emery cloth. If the
problem remains, the message re-
quires action by authorized service
technician.
Reset all user set-
No action required.
Check that the guide wire connector is
tightly connected to the charging sta-
tion. Refer to
on page 21 .
Check if the indicator lamp in the
charging station flashes yellow. Refer
Indicator lamp in the charging station
to
on page 45 . Find out where the break
is. Replace the damaged section of the
guide wire with a new loop wire and
splice using an original coupler.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 21 .
Check that the guide wire is installed
according to the instructions. Refer to
To install the guide wire on page 21 . Al-
so, check that the minimum distance to
the left of the guide wire is met. Refer
To examine where to put the guide
to
wire on page 19 .
To install
Battery
To install the guide wire
1392 - 001 -