Flymo EasiLife 200 Operator's Manual page 26

Function Low
PIN-code
Time lock X
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
3.10.5.1 To set the security level
Select 1 of the security levels for your product.
1. Do steps 1–3 in To get access to the menu
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Security level .
3. Use the arrow buttons and the OK button to
select the level of security.
4. Push the OK button.
3.10.6 Security - Advanced
3.10.6.1 To create a new loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
adjacent installations have very similar signals.
1. Place the product in the charging station.
To get access to the menu
2. Do steps 1–3 in
on page 23 .
3. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
4. Await confirmation that the loop signal has
been generated. This normally takes about
10 seconds.
3.10.6.2 To change the PIN-code
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Advanced > Change PIN-code .
26 - Installation
3. Enter the new PIN code.
High
4. Push the OK button.
X
5. Enter the new PIN code.
X
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3 .
3.10.7 Lawn Coverage and PassageSense
If the work area includes remote parts that are
connected with narrow passages, the
Coverage and PassageSense function are useful
to be able to maintain a well-cut lawn in all parts
of the yard. The
to guide the product to remote parts of the work
PassageSense function is used for
area. The
narrow passage mowing. A guide wire must be
installed to use these functions. You can set a
maximum of 3 remote areas.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a
Settings >
certain distance and starts to mow the lawn.
PassageSense function is suitable to mow
The
narrow passages of 60 cm - 1.5 m / 23 in. - 4.9 ft.
width. The product moves in a pattern to cover
the passage width. The product starts the
PassageSense at the set distance from the
charging station. When the product reaches the
end of the narrow passage, the product continues
and cuts the lawn as normal.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
Security >
A
Settings >
Lawn
Lawn Coverage function is used
C
B
1392 - 001 -