Information And Warning Messages - Flymo EasiLife GO Operator's Manual

6.3 Information and warning messages

The information messages in the table below are shown in the app. Speak to your Flymo service if the same message
shows frequently.
Message Cause
Low battery
The product cannot find the charging station.
The battery is at the end of its life cycle.
The antenna of the charging station is defec-
tive.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Settings restored Reset all user settings has been done.
A
Guide not found
The guide wire is not connected to the charg-
ing station.
Damage in the guide wire.
The guide wire is not connected to the boun-
dary loop.
Loop signal created
New loop signal changed.
Needs manual charg-
The product is set to the
ing
erating mode.
Next start hh:mm
The schedule setting prevents the product
from operating.
The product has operated the maximum cut-
ting time for the day.
Today's mowing The product has operated the maximum cut-
completed
ting time for the day.
Connection NOT
The loop signal was not changed because of
changed
an error.
1622 - 001 - 03.03.2021
Action
Change the position of the guide wire. Refer
To install the guide wire on page 18 .
to
Replace the battery. Refer to
page 29 .
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
lamp in the charging station on page 36 .
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your approved servicing dealer.
Usual operation of the product.
Connect the guide wire to the charging sta-
tion. Refer to
page 18 .
Replace the damaged section with new
guide wire.
Connect the guide wire correctly to the boun-
dary loop. Refer to
on page 18 .
Usual operation of the product.
Secondary area op-
Put the product in the charging station.
Change the schedule settings. Refer to
Park / Schedule on page 24 .
Usual operation of the product.
Usual operation of the product. Refer to
Park / Schedule on page 24 .
Make a
Refer to
problem stays speak to your Flymo service.
Battery on
Indicator
To install the guide wire on
To install the guide wire
New loop signal a number of times.
New loop signal on page 22 . If the
Troubleshooting - 35