Flymo EasiLife 200 Operator's Manual page 42

Message Cause
Safety function
Temporary electronic or firmware rela-
faulty
ted issue in the product.
Electronic problem
Loop sensor prob-
lem, front/rear
Charging system
problem
Tilt sensor prob-
lem
Temporary prob-
lem
Temporary battery
Temporary battery or firmware related
problem
issue in the product.
Battery problem
The product is not allowed to operate if
the battery temperature is too high or
low.
Charging current
Wrong or faulty power supply unit.
too high
Connectivity prob-
Potential problem on the connectivity
lem
circuit board in the product.
Connectivity set-
The connectivity settings was restored
tings restored
due to a fault.
Poor signal quality The connectivity circuit board in the
product is assembled upside down, or
the product itself is tilted or upside
down.
42 - Troubleshooting
Action
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Restart the product.
Disconnect and reconnect the battery.
If the problem remains, the message
requires action by authorized service
technician.
The product starts to operate according
to schedule when the temperature is
within the set limits.
Check that the charging station is
placed in an area with protection from
the sun.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Please check and change the settings
if needed.
Verify the product is not upside down or
tilted. If not, the message requires ac-
tion by authorized service technician.
1392 - 001 -