Flymo EasiLife 200 Operator's Manual page 40

Message Cause
Trapped
The product has got caught in some-
thing.
The product is stuck behind a number
of obstacles.
Empty battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
No drive
The product has got caught in some-
thing.
The work area includes a steep slope.
The guide wire is not laid at an angle
on a slope.
Wheel motor over-
The product has got caught in some-
loaded, left/right
thing.
Wheel motor Grass or other object has wrapped
blocked, left/right
around the drive wheel.
40 - Troubleshooting
Action
Free the product and rectify the reason
for it becoming trapped.
Check if there are any obstacles which
make it hard for the product to move on
from this location. Remove the obsta-
cles or create an island around the ob-
To make an island on
stacles. Refer to
page 17 .
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 21 .
Check if the indicator lamp in the
charging station flashes yellow. Refer
Indicator lamp in the charging station
to
on page 45 . Find out where the break
is and rectify it.
Replace the battery. Refer to
on page 36 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 45 .
Enter the correct PIN code. Contact
Flymo customer service if you forget
the PIN code.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Steep slopes should be isolated. Refer
To examine where to put the boun-
to
dary wire on page 16 .
If the guide wire is laid on a slope, it
must be laid at an angle across the
To examine where to
slope. Refer to
put the guide wire on page 19 .
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Check the drive wheel and remove the
grass or other object.
To install
Battery
1392 - 001 -