Flymo EasiLife 200 Operator's Manual page 43

Message Cause
No loop signal
The power supply is not connected.
The low voltage cable is damaged or
not connected.
The boundary wire is not connected to
the charging station.
The boundary wire is broken.
ECO mode is activated and the product
has attempted to start outside the
charging station.
The boundary wire is crossed on its
way to and from an island.
The signal between the product and the
charging station has been broken.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
1392 - 001 -
Action
Check the wall socket connection and
whether an earth-fault breaker has trip-
ped or not. Check that the low voltage
cable is connected to the charging sta-
tion.
Check that the low voltage cable is not
damaged. Check that it is also properly
connected to the charging station and
to the power supply.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Replace connectors if dam-
To install the boundary
aged. Refer to
wire on page 21 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
Find breaks in the
nal coupler. Refer to
loop wire on page 47 .
Place the product in the charging sta-
tion and push the STOP button. Refer
ECO mode on page 29 .
to
Check that the boundary wire is laid ac-
cording to instructions, e.g. in the right
direction around the island. Refer to
make an island on page 17 .
Place the product in the charging sta-
tion and generate a new loop signal.
To create a new loop signal on
Refer to
page 26 .
Try moving the boundary wire.
Troubleshooting - 43
To