Flymo EasiLife 200 Operator's Manual page 13

2. Push the ON/OFF button for 3 seconds and
make sure the product is switched off.
Check that the indicator lamp on the keypad
is not lit. This means that the product is
Indicator lamp in the
disabled. Refer to
charging station on page 45 .
3. Carry the product by the handle with the
blade disc away from the body.
2.3.4 Maintenance
WARNING: The product must be
switched off before any maintenance is
done. The product is disabled when
the indicator lamp on the keypad is not
lit.
WARNING: Use the plug to disconnect
the charging station before any
1392 - 001 -
cleaning or maintenance of the
charging station or the loop wire.
CAUTION: Never use a high-pressure
washer to clean the product. Never
use solvents for cleaning.
Inspect the product weekly and replace any
damaged or worn parts. Refer to
maintenance on page 35 .
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical
components in the product and the charging
station, we recommend that all connections to the
charging station are disconnected (power supply,
boundary wire and guide wire) if there is a risk of
a thunderstorm.
1. Mark the wires to simplify reconnecting. The
charging station's connections are marked
R, L and GUIDE.
2. Disconnect all connected wires and the
power supply.
3. Connect all the wires and the power supply
if there is no longer a risk of thunder. It is
important that each wire is connected to the
right place.
Introduction -
Safety - 13