Table of Contents
Advertisement
Service recommendations
Your product is uniquely identified by a silver and black
product rating label.
We strongly recommend that your product is serviced at
least every twelve months, preferably by a professional.
Removing and fitting the blade
Switch off, wait until the blade has stopped rotating and
disconnect from the mains electricity supply BEFORE
attempting to remove or refit the blade.
Always handle the blade with care - sharp edges could
cause injury. USE GLOVES.
Removing the Blade
1
To remove the blade bolt, hold the blade firmly with
a gloved hand and with a spanner, loosen the blade
bolt by turning it anti-clockwise (Picture F).
2
Remove the blade bolt, washer and blade.
3
Inspect for damage and clean as necessary.
Renew your metal blade after 50 hours mowing or 2
years, whichever is sooner, regardless of condition. If
the blade is cracked or damaged replace it with a new
one.
Fitting the Blade
1
Fit the blade to the shaft with the sharp edges of the
blade pointing away from the shaft.
2
Re-assemble blade bolt through the washer and the
blade.
3
Hold the blade firmly with a gloved hand and tighten
the blade bolt firmly with a spanner. Do not over
tighten.
Caring for your lawnmower
Cleaning
•
DO NOT use liquids for cleaning.
•
USE GLOVES.
IMPORTANT! After receiving your
!
lawnmower from the manufacturer, it is
very important that you keep your unit
clean. Grass clippings left in any of
the air intakes or under the deck could
become a potential fire hazard.
1
Disconnect lawnmower from the mains electricity
supply.
2
Remove grass from under the deck with a brush.
3
Using a soft brush, remove grass clippings from all
air intakes, the discharge chute and the grassbox.
4
Using a soft brush, remove grass clippings from the
vision window (if equipped).
5
Wipe over the surface of your lawnmower with a dry
cloth.
8 – English
MAINTENANCE
!
Storing your Cable
Your electric cable can be wrapped around hooks to
enable tidy and safe storage.
Storing your Lawnmower
Store in a dry place where your lawnmower is protected
from damage.
Loosen the wing knobs to enable the handles to be
folded over the product ensuring that the upper handle
is supported.
At the end of the mowing season
1
Replace bolts, nuts or screws, if necessary.
2
Clean your lawnmower thoroughly.
3
Make sure that the electric cable is stored correctly
to prevent damage.
Replacement parts
•
Blade 36cm
Part no.: 590605190 - FLY071
Environmental information
•
Awareness of the environment must be considered
when disposing of 'end-of-life' product.
•
If necessary, contact your local authority for disposal
information.
The symbol on the product or on its packaging indicates
that this product may not be treated as household
waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and elec-
tronic equipment.
By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise
be caused by inappropriate waste handling of this
product.
For more detailed information about recycling of this
product, please contact your local council office, your
household waste disposal service or the shop where
you purchased the product.
Guarantee and guarantee policy
If any part is found to be defective due to faulty manu-
facture within the guarantee period, Husqvarna UK Ltd.,
through its Authorised Service Repairers, will effect the
repair or replacement to the customer free of charge
providing:
(a) The fault is reported directly to the Authorised
IMPORTANT! Never use water for
cleaning your lawnmower, as this
could damage the lawnmower and
invalidate the guarantee. Do not clean
with chemicals, including petrol, or
solvents - some can destroy critical
plastic parts.
Hide quick links:
Advertisement
Table of Contents
