Mercedes-Benz S-Class 2020 Operator's Manual page 61

not interfere with the correct routing of Top
Tether belt 4.
Securing the child restraint system with the
seat belt
Securing the child restraint system with the
seat belt on the rear seat
When installing a belt-secured child restraint
system, observe the following:
O Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
O When using a category 0/0+ baby car
seat and a category I rearward-facing
child restraint system on a rear seat:
adjust the front seat so that the seat does
not touch the child restraint system.
O When using a category I forward-facing
child restraint system: remove the head
restraint from the respective seat, if possi‐
ble.
After the child restraint system has been
removed, replace the head restraints imme‐
diately and adjust them correctly.
O The backrest of the forward-facing child
restraint system must, as far as possible, be
resting on the seat backrest of the rear
seat.
O For certain child restraint systems in weight
category II or III, there may be restrictions
on the maximum size setting, e.g. due to
possible contact with the roof.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be installed facing the
wrong direction. Where possible, adjust the
seat cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraint. Adjust
the head restraints accordingly.
O Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
Occupant safety
The seat belts on the following seats are equip‐
ped with a child seat safety feature:
Front passenger seat
R
Rear seats
R
Vehicles with seat belt buckle extenders:
when securing a child in a child restraint system
on a rear seat, observe the following notes:
Make sure that the seat belt is fastened on
R
the child restraint system according to the
manufacturer's installation instructions for
the child restraint system.
For child restraint systems with a belt clamp:
R
engage the seat belt tongue into the seat belt
buckle before you tighten the seat belt using
the belt clamp.
When enabled, the child seat safety feature
ensures that the seat belts of the front
passenger seat and rear seats do not slacken
once the child restraint system is secured
( page 55).
/
59