Mercedes-Benz S-Class 2020 Operator's Manual page 432

Hide thumbs Also See for S-Class 2020:
Table of Contents

Advertisement

430 Breakdown assistance
Pump up the tire again.
#
After a maximum of eight minutes the tire
pressure must be at least 180 kPa (1.8 bar/
26 psi).
& WARNING Risk of accident due to the
specified tire pressure not being ach‐
ieved
If the specified tire pressure is not achieved
after the specified time, the tire is too badly
damaged. The tire sealant cannot repair the
tire in this instance.
Damaged tires and a tire pressure that is too
low can significantly impair braking and han‐
dling characteristics.
Do not drive on.
#
Consult a qualified specialist workshop.
#
If a tire pressure of 180 kPa (1.8 bar/26 psi)
has been attained after eight minutes:
& WARNING Risk of accident from driving
with sealed tires
A tire temporarily sealed with tire sealant
impairs driving characteristics and is not
suitable for higher speeds.
Adapt your driving style accordingly and
#
drive carefully.
Do not exceed the maximum speed
#
limit with a tire that has been repaired
using tire sealant.
Observe the maximum permissible speed for a
tire sealed with tire sealant 50 mph (80 km/h).
Affix the upper section of the TIREFIT sticker
#
to the instrument cluster in a location where
it will be easily seen by the driver.
* NOTE Staining caused by leaking tire
sealant
After use, excess tire sealant may leak out
from the filling hose.
Therefore, place the filling hose in the
#
plastic bag that contained the TIREFIT
kit.
+
ENVIRONMENTAL NOTE Environmental
pollution caused by environmentally irre‐
sponsible disposal
Tire sealant contains pollutants.
Have the tire sealant bottle disposed of
#
professionally, e.g. at an authorized
Mercedes-Benz Center.
Switch off the tire inflation compressor.
#
Unscrew the filling hose from the valve of the
#
faulty tire.
Stow the tire sealant bottle, the tire inflation
#
compressor and the warning triangle.
Pull away immediately.
#
Stop driving after approximately ten minutes
#
and check the tire pressure using the tire
inflation compressor.
The tire pressure must now be at least
130 kPa (1.3 bar/19 psi).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S 450 4matic 2020S 450 2020

Table of Contents