Table of Contents
Advertisement
5. Connect the other end of the cable to the serial port of the Sun Blade 150 platform or
serial port B of the Sun Fire 280R platform.
6. Verify that the DIP switch, which is on the rear of the modem chassis, has the following
settings:
Switch
Setting
If necessary, set the switches.
7. Turn on the modem.
The modem will initialize when the Avaya IR system boots up.
For US customers using the U.S. Robotics Sportster modem, see Sportster Manual for more
information. This document is available in Avaya IR System Help (under "Print documents")
or from the U.S. Robotics Web site (http://www.usr.com/support/s-main-menu.asp).
For international customers, see the documentation from the manufacturer of the modem you
are using.
Configuring the modem
The system is pre-configured to automatically setup the modem for dial-in (for remote
maintenance) and dial-out (for alarming).
If you have trouble with dialing in or out, reset the modem.
To reset the modem:
1. Log in as root.
2. At the command prompt, enter resetModem.
3. Enter setDialInPort ttyx 19200 where x is a for the Sun Blade 150 and b for the
Sun Fire 280R.
4. Enter resetModem
5. Enter setDialInPort disable
6. Enter setDialInPort ttyx 19200
7. Enter resetModem
Note:
If you want to modify the modem configuration after installation, use the Avaya
IR Web Administration interface after the system is set up and running. See
Starting the Web Administration interface on page 60.
1
2
3
Up
Up
Down
4
5
6
Down
Up
Up
Issue 1.0 September 2003 19
Hardware installation
7
8
Up
Down
Advertisement
Table of Contents
