Configuring The Pre-Installed Software - Avaya Interactive Response Installation Manual

― Call Bridge Application (AVxferdip)
― Backup and Restore Utilities (AVbackrst)
― Service Creation (AVsc)
― Feature Test Script (AVftst)
― Disk Mirroring (AVdm) – Installed on the Sun Fire 280R only
Other IR packages, such as NMS, VoIP, and speech packages, must be installed after the
pre-installed software is configured. For more information, see Installing individual packages
on page 44.

Configuring the pre-installed software

Follow the steps in this topic to configure the pre-installed system software, which includes
the Solaris 8 operating system and all the Avaya IR software.
All of the IR base packages are pre-installed. However additional packages are required to
make the system operational. When you complete this procedure, see Installing individual
packages on page 44 for information on how to install additional packages required by your
system.
Note:
Many of the system prompts in this procedure require the use of function keys.
Typically, if the function keys do not work, you can use them by pressing Ctrl+F
then pressing # where # is the function key number. If the terminal type is
xterm, then use the following procedure so the function keys will work properly:
1. Enter export TERM=xterm
2. Enter export SMTERM=xterm
Approximate time required:
Sun Blade 150: 10 minutes
Sun Fire 280R: 10 minutes
Setting up pre-installed software
Issue 1.0 September 2003 23