Table of Contents
Advertisement
LED Status
Off
Green
Red
Encryption:
LED Status
Off
Green
Red
⑤ Dante Network Port
Connects to a network switch to send Dante audio, while receiving Power over Ethernet (PoE) and data from the control
software. See the
Dante and networking
⑥ Reset Button
Resets the device settings back to the factory default.
Power Over Ethernet (PoE)
This device requires PoE to operate. It is compatible with both Class 0 and Class 3 PoE sources.
Power over Ethernet is delivered in one of the following ways:
•
A network switch that provides PoE
•
A PoE injector device
Reset
The reset button is located inside a small hole in the rear panel. Use a paperclip or other small tool to press the button.
There are two hardware reset functions:
Network reset (press button for 4-8 seconds)
Resets all Shure control and audio network IP settings to factory defaults
Full factory reset (press button for longer than 8 seconds)
Restores all network and Designer settings to the factory defaults.
Software Reset Options
To simply revert settings without a complete hardware reset, use one of the following options:
Reboot Device:Power-cycles the device as if it were unplugged from the network. All settings are retained when the device is
rebooted.
Activity
No active signal
Device is operating successfully
Error has occurred. See event log for details.
Activity
Audio not encrypted
Successful encrypted audio connection with another device
Encryption error. Possible causes:
Encryption is enabled on one device and not on another
Passphrase mismatch
section for additional information.
Shure Incorporated
9/27
Advertisement
Table of Contents
