Shure A820-NIC-DANTE Manual

A820-NIC-DANTE -- Dante Network Inter-
face Card

General Description

The A820-NIC-Dante is a network interface that transmits Dante digital audio with standard IP data. This card re-
places a standard network interface in the Shure SCM820 Digital Automixer. Once installed, the SCM820 can net-
work digital audio with any Dante device.

Included Parts

• A820-NIC-Dante Network Interface
• Dante nameplate
Installing the Dante Card into the SCM820
Caution
These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do
not perform any servicing other than that contained in the operating instructions unless you are qualified.
1. Power off and unplug the SCM820 from AC power.
2. Unscrew and remove the top cover.
3. Unscrew the standard nameplate from the back panel and replace with
the Dante nameplate.
4. Locate the network card and unscrew it from the four standoffs.
5. Lift up on the card up to disconnect it from the main board.
6. Position the Dante card to align with the connector on the motherboard.
Gently push down on the card to seat it into the connector.
1/2