Siemens SIMOTION D410 Series Commissioning Manual page 152

Commissioning (software)
4.16 Deleting data
Memory reset using the mode selector switch
The mode selector switch function is implemented in SIMOTION D410 by means of a DIL
switch (DIL = Dual-In-Line). Use this DIL switch (switch S1 - S3) to set the binary code for
the mode of operation.
Information pertaining to to the switch positions and corresponding modes of operation is
available in the
You can only reset memory using the mode selector switch if SIMOTION D410 is operating
in offline mode.
How to reset the memory:
1. Select the MRES operating mode by
2. Set switch 1 to ON (STOP mode) once the RUN/STOP LED permanently lights up yellow.
3. Within 3 seconds, set the switch back to MRES operating mode by setting switch S1 to
4. Wait until the D410 has completed the memory reset (RUN/STOP LED permanently lights
5. Now set the mode selector switch back to the required operating mode; for example, set
Note
Memory reset is cancelled if you do not return the DIL switch to MRES as specified within
three seconds. Repeat the procedure in this case.
152
SIMOTION D410
– Setting mode selector switches S1 to S3 to OFF AND
– Using the service selector switch to ensure that no service functions are selected (S4
to S7 = OFF).
The RUN/STOP LED will begin flashing soon after this (slowly flashing yellow).
Figure 4-41 MRES switch position
OFF again. The memory reset is performed (the RUN/STOP LED flashes yellow quickly).
up yellow).
switches S1, S2, and S3 to ON for RUN mode.
NOTICE
Please note that, during startup, the MRES setting will cause the factory settings to be
restored. For details, refer to the section titled Restoring the default settings of
SIMOTION D410 (Page 154).
Make sure you do not accidentally switch the power supply OFF/ON while MRES is set,
as this will re-establish the factory settings instead of performing a memory reset.
Manual.
SIMOTION D410
Commissioning Manual, 02/2012