Checking The Spark Advance - PIAGGIO XEVO 125 Euro 3 Service Station Manual

Maintenance
Tyre pressure and wear - check
Vehicle and brake test - road test
(*) See instructions in the «Idle speed adjustment» section
Carburettor
- Disassemble the carburettor in its parts, wash all of them with solvent, dry all body grooves with
compressed air to ensure adequate cleaning.
- Check carefully that the parts are in good condition.
- The throttle valve should move freely in the chamber. Replace it in case of excessive clearance due
to wear.
- If there are wear marks in the chamber causing inadequate tightness or a free valve slide (even if it
is new), replace the carburettor.
- It is advisable to replace the gaskets at every refit
WARNING
PETROL IS HIGHLY EXPLOSIVE ALWAYS REPLACE THE GASKETS TO AVOID PETROL LEAKS

Checking the spark advance

- To check ignition advance, use the stroboscopic
light with induction pincers connected to the spark
plug power wire.
- Connect the induction pincers being careful to
respect the proper polarity (the arrow stamped on
the pincers must be pointing at the spark plug).
- Place the light selector in central position (1 spark
= 1 crankshaft turn as in 2-T engines).
- Start the engine and check that the light works
properly and the rpm indicator can read also the
high rpm (e.g. 8000 rpm).
- If flash unsteadiness or revolution reading error
is detected (e.g. half values), increase the resistive
load on the spark plug power line (10 ÷ 15 KΩ in
series to HV wire).
- Remove the plastic cover from the slot on the fly-
wheel cover.
- Operating on the flash corrector displacement of
the bulb, make the reference on the flywheel cover
coincide with level on the water pump drive. Read
MAIN - 6
Action
XEVO 125 Euro 3