PIAGGIO XEVO 125 Euro 3 Service Station Manual page 91

XEVO 125 Euro 3
•
Cut the clamp on the transmission
crankcase duct; after that, disconnect
the pipe connected to the air intake on
the chassis.
•
Disconnect the electric connector link-
ing the magneto flywheel to the vehicle
cable harness.
•
Remove the starter motor electrical
connections acting on the two screws.
•
Remove the footrest and the left side
fairing; move the lower central cover
slightly to the outside and remove the
three screws fixing the supporting plate
of the swinging arm buffer.
•
Remove the buffer sealing seeger ring
and remove the supporting plate of the
swinging arm buffer.
•
Support the vehicle adequately with
the jack. Remove the engine-swinging
arm fixing pin by acting on the nut and
the pin head as shown in the figure.
•
The engine is now free.
Engine from vehicle
ENG VE - 5