Steering Bearing - PIAGGIO XEVO 125 Euro 3 Service Station Manual

Table of Contents

Advertisement

XEVO 125 Euro 3
- Install the handlebars on the steering tube, pay-
ing attention to the centring, aligning the recess on
the handlebar with that on the steering tube as
shown in the figure.
- Tighten the handlebar fixing screw on the steer-
ing tube to the prescribed torque.
- Refit the three handlebar covers as described in
the «Bodywork» Chapter.
- Install the front wheel.
- Refit the brake calliper on the fork leg.
Specific tooling
020055Y Wrench for steering tube ring nut
Locking torques (N*m)
screw fixing handlebar to the steering tube 45
÷ 50 Upper steering ring nut 30 ÷ 36 Steering
lower ring nut 10 ÷ 13 then loosen by 90° Tight-
ening screw for calliper support to the fork 45
÷ 55 Front wheel shaft 45 ÷ 50
See also
Refitting the front wheel

Steering bearing

Removal
- Remove the fork
- Check that the upper ball bearing and the seat of
the lower roller bearings do not show signs of wear
or pricking.
In case of replacement, proceed as follows:
- Using a punch to remove the bearings, insert it
from the bottom and remove the ball bearing
above the headstock. Then remove the lower seat
of the roller bearing by inserting the punch from the
top of the headstock.
N.B.
ONLY REMOVE THE UPPER BALL BEARING IF
YOU REALLY NEED TO.
Suspensions
SUSP - 11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents