Inspecting The Hub Shaft; Inspecting The Hub Cover; Refitting The Wheel Axle Bearing - PIAGGIO XEVO 125 Euro 3 Service Station Manual

XEVO 125 Euro 3

Inspecting the hub shaft

- Check the three shafts for wear or distortion of
the toothed surfaces, the bearing housings, and
the oil seal housings.
- In case of anomalies, replace the damaged com-
ponents.

Inspecting the hub cover

- Check that the fitting surface is not dented or distorted.
- Check the bearing bearings.
- In case of anomalies, replace the damaged components.

Refitting the wheel axle bearing

Support the hub cover on a wooden surface.
- Heat the cover crankcase with special heat gun.
- Fit the wheel shaft bearing with a modular punch
as shown in the figure.
Specific tooling
020150Y Air heater support
020151Y Air heater
020376Y Adaptor handle
020360Y Adaptor 52 x 55 mm
020483Y 30 mm guide
Assemble the seeger ring.
Engine
ENG - 19