Front Brake Pads - PIAGGIO XEVO 125 Euro 3 Service Station Manual

Braking system
Specific tooling
020335Y Magnetic support for dial gauge

Front brake pads

Removal
Proceed as follows:
- Remove the front calliper.
- Loosen the two pins shown in the figure that lock
the two pads.
- Remove the pads, being careful with the pad
spring clamp.
- Check the thickness of the friction material of the
pads.
- Replace the pads if the thickness is below the
minimum value.
- The replacement must be made with greater re-
sidual thickness if the pad has not worn evenly. A
0.5 mm thickness difference in the residual friction
material is permitted.
Characteristic
Minimum value
1.5 mm
See also
Front brake calliper
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque, and apply the recommended product.
- Fit the calliper on its support, tightening the two screws to the prescribed torque.
BRAK SYS - 6
XEVO 125 Euro 3