Sas Filters Inspection And Cleaning - PIAGGIO XEVO 125 Euro 3 Service Station Manual

Maintenance
Proceed as follows:
1. Position the unloaded vehicle, in running order
and with the tyres inflated to the prescribed pres-
sure, on a flat surface 10 m away from a half-lit
white screen; ensure that the longitudinal axis of
the vehicle is perpendicular to the screen;
2. Turn on the headlight and check that the bor-
derline of the projected light beam should be lower
than 9/10 of the distance from the ground to the
centre of the vehicle's headlight, and higher than
7/10;
3. If not, adjust the headlight by turning the central
screw «A» underneath the Piaggio badge.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH
THE EUROPEAN STANDARDS REGARDING
MAXIMUM AND MINIMUM HEIGHT OF LIGHT
BEAMS. REFER TO THE STATUTORY REGU-
LATIONS IN FORCE IN EVERY COUNTRY
WHERE THE vehicle IS USED.

SAS filters inspection and cleaning

Remove the secondary air filter cover after undo-
ing the 3 fixing screws «A», then remove the fil-
tering element «B».
- Wash with water and mild soap.
-Dry with a clean cloth and short blasts of com-
pressed air.
CAUTION
NEVER RUN THE ENGINE WITHOUT THE SEC-
ONDARY AIR FILTER
CAUTION
WHEN TRAVELLING ON DUSTY ROADS, THE
AIR FILTER MUST BE CLEANED MORE OFTEN
THAN SHOWN IN THE SCHEDULED MAINTE-
NANCE CHART.
MAIN - 16
XEVO 125 Euro 3