PIAGGIO XEVO 125 Euro 3 Service Station Manual page 188

Suspensions
Refitting
Using the appropriate tool, refit the upper ball bear-
ing and the seat of the lower roller bearings on the
headstock as described below:
- Place a new ball bearing on the headstock and a
roller bearing seat on the lower part.
- Insert the tie rod screw of the appropriate tool
fitted out with the adaptors for planting the bearing
and seat it in the headstock as in the photograph.
- Using two 24 mm wrenches, tighten the screw
until the seat and the bearing are fully set in place.
N.B.
ALWAYS USE A NEW BEARING AND A NEW
SEAT.
Specific tooling
001330Y Tool for fitting steering seats
SUSP - 14
XEVO 125 Euro 3